Aeropro CZ A220, Maintenance Manual

Page: 90 / 158

Maintenance Manual
AEROPRO CZ 10-19
Maintenance Manual
March 21, 2020
a.
Push the throttle to the full throttle position and check that both the actuator arms on the
carburetor achieve its maximum position.
b. Adjust the locknut at the carburetor end of the control as required to achieve the maximum travel
of each actuator lever.
c. Pull the throttle control to the idle position.
d. Check that both the idle stop screws contact its idle lock and adjust if
required.
e.
Check the idle speed in accordance with paragraph 10.27.
f. Check carburetor synchronizing in accordance with paragraph 10.28.
g. Tighten the rod end locknuts at carburetor end of control. Be sure to maintain sufficient thread
engagement between the rod end and the control.
10.38 Choke control
a.
Push the choke control to the off-position.
b. Check the cable tension for proper setting at the carburetor end of control, adjust if required
(choke arms on each carburetor must touch to its locks in the off position).
c. Pull the choke control to on-position.
d. Check that both arms on the carburetor achieve their maximum travel at the same time. If
required readjust controls at the locknut on carburetor arm.
e. Tighten the rod end locknuts at the carburetor end of the control. Be sure to maintain sufficient
thread engagement between the rod end and the control.
10.39 Carburetor heat control
a.
Push the carburetor heat control to off-position.
b. Check the cable tension for proper setting at the end of the control, adjust if required (the
carburetor heat arm must touch its locks in the off position).
c. Pull the carburetor heat control to on-position.
d. Check that both the arms on the carburetor heat achieve their maximum travel. If required
readjust the controls at the locknut on the carburetor heat arm.
Note Before rigging the throttle control ensure that the control cables are in good condition.
Note
Refer to the inspection chart in Section 2 for inspection and / or replacement interval
for the throttle control.
Note Before rigging the choke control ensure that the control cables are in good condition.
Note
Refer to the inspection chart in Section 2 for inspection and / or replacement interval
for the choke control.
Note
Before rigging the carburetor heat controls ensure that the control cable is in good
condition.