Aeropro CZ A220, Maintenance Manual

Page: 45 / 158

Maintenance Manual
AEROPRO CZ 5-4
Maintenance Manual
March 21, 2020
7. remove both bolts attaching main gear to fuselage.
8. remove main gear assembly.
Installation of the main gear has to be carried out in reversed order to removal.
5.6 Repair of fuselage and wheel fairings
5.6.1 Required Tools: as required
5.6.2 Parts required: epoxy resin, glass fiber tape, rovings, fabrics.
5.6.3 Level of Maintenance: Heavy
5.6.4 Certification required: A&P Mechanic or LSA Repairman Maintenance
Repair of main gear is limited to the repair of the wheel fairings. If cracks are dedected in the glass fiber
fairings, they may be repaired using L285 Epoxy Resin or similar (R&G L20), reinforcing with suitable
carbon fiber fabrics. Follow the instructions on the container for a successful completion of the repair. If
cracks in the undercarrage legs are present, the main gear has to be replaced, except if cracks are only
related to the paint finish. If in doubt, always replace the main gear.
5.7 Main Wheel Removal
5.7.1 Required Tools: 27mm socket (for axle nut), 13mm wrench, etc.
5.7.2 Parts required: None
5.7.3 Level of Maintenance: Line
5.7.4 Certification required: A&P Mechanic, LSA Repairman Maintenance or Owner
To remove main wheel follow steps 1 and 3, outlined in paragraph 5.5 and then
proceed as described below (refer to figure 5-2.):
Figure 5-2
1, 2, 3 -- 8mm bolts holding brake rotor onto inner wheel half
4. axle flange nut on the main wheel axle
5. 6x screw M6 (with 6x 6mm washers and 6mm nylock nuts)