Serial Number 1646
Date of Issue: 23 June 2017
Revision - Original
28
Final approach
Speed
65-70 knots
Throttle
As necessary
Flaps Set to 15° - 40
o
position and continue to final maintaining speed at 60-65 kt.
Trim As necessary
Landing
Speed
50-55Knots
Flaps
40° position
Trim
As necessary
At approx. 15 ft. height above runway, start pulling the yoke to reduce descent rate; at approx. 1 ft.
above runway, let the plane loose speed gradually, until the main wheels touch down.
Always touch down on main landing gear wheels.
Pull up yoke gradually to maintain nose gear above ground for as long as possible.
When nose gear finally touches down, apply brakes as necessary.
If runway is short or clearway is high, extend the flaps to 40°. With the flaps in this position, descend
rate increases markedly. Maintain speed 50 knots.
Go-around
Throttle
Full engine power (5700 rpm max.)
Flaps
Retract to “take-off” position
Start climbing
Speed at least 55 kt. IAS
Trim
As necessary
Adjust speed for
65 knots IAS climbing
Flaps
Retract, at the minimum height above ground of 150-200ft
Trim
As necessary