Glue together parts 3 to 5 to assemble the boatstand.
When glue has dried apply several coats of sanding sealer.
Sand lightly with 400-grit sandpaper.
Glue together two rear keel parts 6, sand edges
smooth, then apply two coats of sanding sealer.
Sand lightly with 400-grit sandpaper.
Trim the vacuum-formed hull at the line indicated in illustration.
Use a sharp scalpel or similar and scratch along the inside of the hull´s top edge several times with
only little pressure. Then carefully break off the edge along the engraved line.
With a small balsa plane or sanding block smooth the top edge of the hull.
1
2
4
3
3
5
5
6
6
4
Drill a 7 mm hole for propshaft 7 and a 4 mm
hole for rudder sleeve 8 into the rear end of the
hull as indicated.
The exact positions for the holes are marked on
the hull.
Building the Hull
