Aero Easy Cover, Installation Instructions Manual

Page: 13 / 40

13
Easy Cover ®
Installation Instructions
Step 3a
Installing the Sprocket
1) See Figure 13. Slide the sprocket (1) over the
outside of the shaft of the driver's side roll up bar.
Position sprocket so that it aligns with the crank
assembly sprocket.
2) Lightly tap the key (2) into the shaft keyway.
3) Tighten the Allen set screw on the sprocket until it
begins to feel tight. Make sure the screw engages the
key (2). Do not over tighten.
Step 3b
Installing Manual Crank Assembly
 

1) Remove the cover (if installed) on the crank assembly and
lay cover aside until after the chain is installed.
2) See Figure 14. Place the crank assembly at or near the
bottom front corner of the box on the driver's side. Rotate
the crank assembly so that it angles toward the tarp roll up
bar.
3) Mark the mounting holes on the box. Drill marked holes
using 13/32" drill bit.
4) Fasten the crank assembly to the box with bolts, washers,
and nuts. Make sure to bolt the assembly in the highest
upward position.
Index Description Qty
1 Crank Assembly 1
2 3/8 x 1 Self Tapping Hex Bolt 1
Index Description Qty
1 Sprocket 1
2 Key 1
5GV5ETGY
5JCHV-G[YC[
Figure 13
Figure 14
2
1
1
2