Aero Easy Cover, Installation Instructions Manual

Page: 35 / 40

35
Easy Cover ®
Installation Instructions
Step 7b
Installing Upper Swing Arms and Cross Arm
  
1) See Figure 46. Insert arm casting (4) into upper swing arm (3) and secure with 3/8-16 x 2 hex bolt (8) and
3/8-16 Nylon hex nut (11). Repeat for second arm casting (4) and upper swing arm (3).
2) See Figure 46. Slide upper swing arm (3) into lower swing arm and insert 3/8-16 x 3/4 hex bolts (6) into
the 2 tapped holes of the lower swing arm. Repeat on opposite side.
3) Roll out tarp (1) in bed of truck.
Make sure the pocket is at the
rear of the truck.
4) Insert cross arm (2) through the
pocket in the tarp (1) at the tail
gate, center and place on the
bed.
5) Insert 1/4-20 x 1 hex bolt (7)
into each rubber bumper and
attach 1/4-20 Nylon hex jam nut
(10).
6) Slide 2 rubber bumpers (5) onto
each side of the cross arm (2).
7) Lift one swing arm and insert cross arm (2) into arm casting (4). Insert far enough
so opposite swing arm can be lifted and inserted through the opposite arm casting
(4).
8) See Figure 47. Adjust cross arm (2) on one side to extend 1/2"-3/4" beyond arm
casting (4).
Index Description Qty
1 Tarp 1
2 Cross Arm 1
3 Upper Swing Arm 2
4 Arm Casting 2
5 Rubber Bumper 2
6 3/8-16 x 3/4 Hex Bolt 4
7 1/4-20 x 1 Hex Bolt 4
Index Description Qty
8 3/8-16 x 2 Hex Bolt 2
9 3/8-16 x 3 Hex Bolt 2
10 1/4-20 Nylon Hex Jam Nut 6
11 3/8-16 Nylon Hex Nut 4
12 1/4-20 x 2 1/2 Eye Bolt 2
13 4" Tension Spring 2
14 Plug End 2
Figure 46
3
4
5
6
7
8
9
10
14
2
11
10
12
13
1/2" - 3/4"
Figure 47