„AERO” Sp. z o. o.
SECTION 4
AT-3 R100
NORMAL PROCEDURES
JULY, 2010
Page 4-9
AEROPLANE FLIGHT MANUAL
4.5.3. Using an electric ground power source
The aeroplane is equipped to use electric power from external sources.
A typical power receptacle (of 11041 – type) is installed at the port side
of the fuselage, in front of the wing. The polarity of the delivered
connecting cable is marked on it. Special attention is to be given to the
correct polarity, when connecting to the external source (Battery). The
voltage of the external source must be 12 to 14 Volts.
The engine starting procedure, when using an external power source, is
the same as when using the aeroplane’s own battery.
After completing engine start, the external source is to be disconnected
from the aeroplane.
CAUTION
Incorrect connection of the poles may result in damage of the
electrical system of the aeroplane
4.5.4. Engine starting
CAUTION
During conducting the engine test, in spite of brakes using the
aircraft can be move. To avoid this it is recommended additional
securing the aircraft against move by chocks putted under wheel.
Take special care during the engine starting and testing without
apply chocks under the wheel.
CAUTION
Engine started is prohibited with the parking brake on
9
9
9
9
