145
Inspection (continued) -
Closely examine the inside of the Battery Compartment(s) for any signs of corrosion
indicating entrance of moisture into the unit.
If corrosion is found, return the Elite T3 system to an Authorized AERIS Dealer, and
DO NOT attempt to use it until it has received factory service.
If moisture is found, it is best to have the unit inspected and cleaned by an Authorized
AERIS Dealer.
If it is necessary to clean the Battery Compartment, flush it and all components with a
solution of 50% white vinegar and 50% fresh water. Rinse with fresh water, and
allow to dry overnight, or blow dry with a hair dryer set at no heat.
Elite T3 Battery Installation
Slide a new 3 volt type CR2450 Lithium Battery, negative ( - ) side down into the
Battery Cavity. Slide it in from the right side and ensure that it slides under the contact
clip on the left rim of the cavity.
Orient the Retaining Bar across the lower portion of the Battery and carefully push it
down into position.
Replace the Hatch O-ring with a new one. This O-ring must
be a genuine AERIS part that can be purchased from an
Authorized AERIS Dealer. Use of any other O-ring will void
the warranty.
Lightly lubricate the new Hatch O-ring with silicone grease
and place it on the inner rim of the Battery Hatch. Ensure
that it is evenly seated.
Slide the Hatch Ring, top portion first (small opening), onto
your thumb (Fig. 129).
Fig. 129 - Elite T3 BATTERY
INSTALLATION
