Chapter 2
Innovation Series Water Heaters
GF-128
Installation
USER MANUAL
OMM-0079_0B
07/21/11 AERCO International, Inc.
•
100 Oritani Dr.
•
Blauvelt, NY 10913
•
Ph: 800-526-0288
Page
13
of
200
CHAPTER 2. INSTALLATION
2.1
INTRODUCTION
This Chapter provides the descriptions and procedures necessary to unpack, inspect and install AERCO
Innovation Water Heater Models INN 600, INN 800 and INN 1060.
2.2
RECEIVING THE UNIT
Each Innovation Water Heating System is shipped as a single crated unit. The shipping weight is
approximately
1200 pounds. The unit must be moved with the proper rigging equipment for safety and to
avoid equipment damage. The unit should be completely inspected for evidence of shipping damage and
shipment completeness at the time of receipt from the carrier and before the bill of lading is signed.
NOTE
AERCO is not responsible for lost or damaged freight. Each unit has a Tip-N-Tell
indicator on the outside of the crate. This indicates if the unit has been turned on
its side during shipment. If the Tip-N-Tell indicator is tripped, do not sign for the
shipment. Note the information on the carrier’s paperwork and request a freight
claim and inspection by a claims adjuster before proceeding. Any other visual
damage to the packaging materials should also be made clear to the delivering
carrier.
2.3
UNPACKING
Carefully unpack the unit taking care not to damage the unit enclosure when cutting away packaging
materials
After unpacking, a close inspection of the unit should be made to ensure that there is no evidence of
damage not indicated by the Tip-N-Tell indicator. The freight carrier should be notified immediately if any
damage is detected.
The following accessories come standard with each unit and are either packed separately within the unit’s
shipping container or are factory installed on the unit:
•
Pressure/Temperature Gauge
•
Spare Spark Igniter-Injector
•
Spare Flame Detector
•
ASME Pressure Relief Valve
•
Condensate Drain Trap
•
1-1/2” Gas Supply Shutoff Valve
When optional accessories are ordered, they may be packed within the unit’s shipping container, factory
installed on the unit, or packed and shipped in a separate container. Any standard or optional accessories
shipped loose should be identified and stored in a safe place until ready for installation or use.
2.4
SITE PREPARATION
Ensure that the site selected for installation of the Innovation Water Heater includes:
•
Access to AC Input Power at 120 VAC, Single-Phase, 60 Hz @ 20 Amps.
•
Access to Natural Gas line at a minimum pressure of 4 inches W.C.
