AEP Networks ATAG VA4511AT, User Manual

Page: 28 / 67

- 28 -
10.2001 A. B. 599 51 21 26 EN
- What happens when opening and closing the door?
o
The appliance is switched on and is in the “pre-start mode”.
+
After opening, all displays (see Instructions Point 3 “Before the start”) continue to
light on the panel. The power supply of the electronics is fully guaranteed as long
as the appliance keeps to be switched on by the ON/OFF key.
+ The door LED lights in addition.
o The door is opened during the running cycle.
(see chapter “Interrupt the cycle / pause mode”)
o The door is opened when the cycle end has been reached.
+
When the cycle end was reached and the door opened and closed again, the
appliance is automatically again in the “pre-start” mode.
- Display of remaining time
o
The remaining time indicates the expected running time of the set cycle combination.
o The display is indicated in minutes.
o The display of the remaining cycle running time is indicated by a 7-segment display.
o The display is 2 1/2-digit. This means a maximum of “199” minutes can be displayed.
With times more than 199 minutes, the time 199 is indicated steadily until the cycle
running time is below that value. Only from that moment the remaining time will be
updated again automatically.
o After switching on the appliance without having set a washing cycle, the 7-segment
display and the running time LED will remain dark.
o If a washing cycle has been set, the LED “running time” gives a red light, the 7-segment
display flashes and will light permanently from the cycle start.
o The indicated times are to be taken from a table which is coordinated with the particular
process steps. A correction factor depending on the load is considered when
calculating the running time.
o If the door is opened during the washing or final rinse phase, this may for technical
reasons result in “jumps” of the running time display when closing the door again.
o Digit “1” (= 1 min) shortly before the end of the cycle will be indicated as long as the
appliance is still “working”. Digit “0” will be
Information: The 7-segment display among other things also indicates the fault display.
(see chapter “Table of fault displays”)
- Cancel a Cycle
o
An already started cycle can be cancelled by actuating the current cycle key for at least
3 seconds. During these 3 seconds, the corresponding cycle key flashes. After the time
has passed, the cycle selection is reset.
o The 7-segment display resp. the LED of the cycle running display go out.
o (see chapter “Before the Start”)