THE DURESS CODE
(A SOFTWARE ZONE)
The duress code does not need to be programmed. The system determines it automatically by
increasing the first digit of the user code(s) of
units. All 8 user codes can accept the entry
for duress function.
TWO
Example:
User Code 1328, Duress Code 3328
or User Code 8312, Duress Code 0312
or User Code 0856, Duress Code 2856
When program the system with more than one user codes, it is important that the user
codes will not fall into the duress code of other user codes.
For example, if user code 1 is 1328, it is not allowed to make other user code to 3328, as
3328 is the duress code of user code 1.
The duress function only activates the communicator and the telephone dialer without
activating of the local alarm outputs
. Make sure that at least either the
dialer or the communicator is enabled for reporting alarms. Otherwise, the duress code can
give no function.
The following is the description of the duress code operation. It is not a programming
procedure.
To command the duress function, enter the duress code and validate via the [#] key.
DURESS CODE
#
The duress code is valid at anytime no matter the system is armed or disarmed. The system
exhibits the following behaviours when the duress code is entered.
System behaviours:
Important Notes:
!
!
!
!
!
!
(the siren & strobe)
USING THE DURESS CODE
PROGRAMMING THE PANEL
BEFORE KEYING - IN THE DURESS CODE
System was armed
System was disarmed
AFTER KEYING - IN THE DURESS CODE
System is disarmed and starts dialing for
reporting alarm
System is still disarmed and starts dialing for
reporting alarm.
18
HA-266
CLEAR THE ALARM MEMORY
CLEAR THE ALARM MEMORY AND RE-ARM THE SYSTEM IN ONE TIME
It is necessary to clear the alarm memory before you can re-arm the system.
USER CODE
3
#
The zone LEDs with alarm memory will be OFF to show that the alarm memory has been
cleared.
The system keeps in disarmed mode.
The system is ready for rearm anytime.
The following command can help you to clear the alarm memory and at the same time to re-arm
the system.
USER CODE
6
#
The zone LEDs with alarm memory will be OFF to show that the alarm memory has been
cleared.
The control console will give 2 beeps to confirm that the system is ON and EXIT DELAY
is started, the EXIT/ARMED LED will flash.
The system will be armed after the EXIT DELAY expired, the EXIT/ARMED LED will be ON.
Enter your [USER CODE], press the [ ] key, enter number [3] and validate by [#] key.
Enter your [USER CODE], press the [ ]key, enter number [6] and validate by [#] key.
!
!
!
!
!
!
DISARM THE SYSTEM AND CLEAR THE ALARM MEMORY
59
HA-266
