3. USE THE DAP JUMPER DIRECTLY ACCESS TO PROGRAMMING MODE
If the factory set master code was deleted and the personal master code is forgotten. Use the
DAP jumper to override the forgotten code permitting direct entry into programming mode. The
DAP jumper can be found on the master circuit board. The owner is required to apply the
following procedures precisely when use the DAP jumper:
i ) Disconnect the power supply.
ii ) Displace the DAP jumper from OFF to ON position.
iii ) Reconnect the power supply, the console will beep continuously.
iv ) Put the DAP jumper back to OFF position, the beep stops and the
LED is ON.
v ) The system is in programming mode now, and it is ready to receive new data.
vi ) The DAP jumper is normally left on OFF position after programming.
After the system is set in programming mode, you can start to program the system with your
desired programming values. You can make the programming for all the program options
continuously or just select those options that you require. It is not necessary to make the
programming in order sequence; you can jump to any
that is available
in the system.
The master code can be 2 digits minimum to 5 digits maximum.
When the new personal master code is entered, the factory set master code or the code
that was programmed will be erased
.
PROGRAM
Programming Location
RECORDING THE MASTER CODE
(Location: 01)
LOCATION
MASTER CODE
VALIDATION
0 1
2 TO 5 DIGITS
#
!
!
START THE PROGRAMMING
PROGRAMMING THE PANEL
16
HA-266
ON OFF
DAP
EMERGENCY CASES
MAKE A PANIC ALARM
MAKE A DURESS ALARM
(A Software Zone)
(A Software Zone)
At anytime, hold down any TWO key buttons on the control console simultaneously for three
seconds will trigger an alarm. The console will give 2 beeps to confirm the alarm condition.
Local alarms will be given.
Communicator
will send a panic alarm report.
The dialer
will contact the programmed telephone numbers and send the
message.
There will be no indication of an alarm condition on the control console.
This feature is available ONLY at the condition that the communicator or the dialer is enabled.
Otherwise, making a duress alarm is not possible.
Should an intruder force you to turn your security system OFF, you can send a silent DURESS
alarm signal to the monitor station and send the recorded message to the programmed
telephones.
The duress code is made by adding 2 to the 1st digit of your USER CODE(s). For example, if
your User Code is [1357], enter [3357] will trigger a silent alarm
.
DURESS CODE
#
No local alarm will be given.
Communicator will send a duress alarm report.
The dialer will contact the programmed telephones and send the message.
There will be no indication of an alarm condition on the control console.
The system will be turned
if it is in
or in
condition.
The system will keep itself in
condition if it is
.
ANY TWO KEY BUTTONS ON THE CONTROL CONSOLE
Enter your [DURESS CODE], and validate by [#] key.
!
!
!
!
!
!
!
!
!
!
(if enabled)
(if enabled)
(Duress)
OFF
ARMED
ALARM MEMORY
OFF
OFF
61
HA-266
