AEG LWM8C1612S, User Manual

Page: 42 / 48

Problem Possible solution
The laundry is full of dif‐
ferent colours fluff.
The fabrics washed in the previous cycle released fluff of a dif‐
ferent colour:
• The drying phase helps to eliminate some fluff.
• Clean the clothes with a fluff remover.
In case of an excessive amount of fluff in the drum run the spe‐
cial programme to clean it (refer to “Fluff in the fabrics" for
more details).
After the check, activate the appliance. The programme continues
from the point of interruption.
If the problem occurs again, contact the Authorised Service Centre.
If the display shows other alarm codes. Deactivate and activate the
appliance. If the problem continues, contact the Authorised Service
Centre.
16.3 Emergency door
opening
In case of power failure or functioning
failure the appliance door remains
locked. The washing programme
continues when the power is restored. If
the door remains locked in case of
failure, it is possible to open it using the
emergency unlock function.
Before opening the door:
CAUTION!
Risk of burns! Make sure
that the water temperature
is not too high and the
laundry is not hot. If
necessary, wait until they
cool down.
CAUTION!
Risk of injury! Make sure
that the drum is not
rotating. If necessary, wait
until the drum stops
rotating.
Make sure that the water
level inside the drum is
not too high. If necessary,
proceed with an
emergency drain (refer to
«Emergency drain» in
«Care and cleaning»
chapter).
To open the door, proceed as follows:
1. Press the Marche/Arrêt button to
switch the appliance off.
2. Disconnect the mains plug from the
mains socket.
3. Open the filter flap.
4. Pull twice the emergency unlock
trigger downward and open the
appliance door.
5. Take out the laundry and then close
the appliance door.
6. Close the filter flap.
www.aeg.com 42