AEG LWM8C1612S, User Manual

Page: 16 / 48

the programme ends with water in the
drum. This helps to reduce creasing.
As the programme is very quiet, it is
suitable for use at night time when
cheaper electricity tariffs are
available. In some programmes the
rinses are performed with more water.
The display shows the indicator .
The door stays locked. The drum
turns regularly to reduce creasing.
You must drain the water to unlock
the door.
Touch the Départ/Pause button: the
appliance performs only the draining
phase.
The appliance empties the
water out automatically after
approximately 18 hours.
6.5 Tache/Prélavage
Press this button repeatedly to activate
one of the two options.
The relevant indicator goes on in the
display.
• Tache
Select this option to pre-treat heavily
soiled or stained laundry using stain
remover.
Pour the stain remover into
compartment
. The stain remover
is pre-mixed and heated with
detergent in order to improve its
effectiveness.
This option can increase
the programme duration.
This option is not
available with a
temperature lower than
40 °C.
• Prélavage
Use this option to add a prewash
phase at 30 °C before the washing
phase.
This option is recommended for
heavily soiled laundry, especially if
containing sand, dust , mud and other
solid particles.
This option can increase
the programme duration.
These two options cannot be
set together.
6.6 Départ Différé
With this option you can delay the start of
a programme in a more convenient time.
Tap on the button repeatedly to set the
required delay. The time increases by
steps of 30 minutes up to 90' and from 2
hours up to 20 h.
After starting the cycle by the means of
the Départ/Pause button, the display
shows the selected delay time and the
appliance begins the countdown.
6.7 Gain de temps
With this option you can decrease the
programme duration.
• If your laundry is normally or lightly
soiled, it may be advisable to shorten
the washing programme. Touch this
button once to decrease the duration.
• In case of smaller load, touch this
button twice to set an extra quick
programme.
On the display the programme duration
is adjusted accordingly.
When this button is set, the led above
the button is on.
This option can also be used
to shorten the Vapuer
programme duration.
6.8 Antifroissage
This option adds a short anti-crease
phase at the end of the programme.
This phase reduces fabric creasing and
facilitates the fabric ironing.
When this option is set, the led above the
button is on and then blinks during anti-
crease phase.
This option can increase the
programme duration.
By touching any button the anti-crease
movements stop and the door unlocks.
www.aeg.com 16