37
Chapter 3
3.3 Installing a Hard Disk
The procedure for installing a hard disk into the UNO-3072L is listed
below. Please follow these steps carefully.
1.
Remove the power cord.
2.
Unscrew the two screws from the upper HDD cover
3.
Unscrew the four screws from the upper cover and remove it.
4.
Install the HDD in HDD bracket and secure with the four screws.
5.
Connect the IDE flat cable to Primary (recommended; CN1 of main-
board) or secondary IDE connector (CN2 of mainboard), then con-
nect the other side of the connector to the hard disk. (Figure 3.1)
6.
Screw on the upper cover with the four screws.
Figure 3.1: Location of IDE Connector (CN1 and CN2)
3.4 Installing a PCI-bus Card
The procedure for installing a PCI-bus card into the UNO-3072L is listed
below. Please follow these steps carefully.
1.
Remove the power cord.
2
.
Remove the upper cover of UNO-3072L.
3.
Unscrew the screw of a PCI bracket, and remove it.
4.
Plug-in PCI-bus card in a PCI-slot of UNO-3072L.
5.
Screw the 1st anti-vibration rubber towards the 1st PCI card until it
is fixed. (Figure
3.2).
Summary of Contents for UNO-3072L
Page 16: ...UNO 3072L User Manual 8 1 4 Chassis Dimensions Figure 1 1 Chassis Dimensions for C M 1GHz CPU...
Page 17: ...9 Chapter1 Figure 1 2 Chassis Dimensions for C M 1 5GHz or faster CPU...
Page 51: ...APPENDIX A System Settings and Pin Assignments...