Advantech PCL-843, Manual

Page: 18 / 36

12 PCL-843 User's Manual
Configuration using software
To set up the PCL-843's configuration using the software utility,
follow the procedures below:
Step 1. Ensure that jumper JP4 (pins 3 and 4) is open
Step 2. Run the SETUP.EXE file located in the root directory of the
software utility diskette. The software will then bring you to
the software setup screen as shown below.
Setup/diagnostic main screen
Step 3. For initial setting up of you card select "S" for setup. The
other option "D" is for later diagnostic testing.
Step 4. When you select setup the screen shown on the next page will
appear. Move the highlight bar to the setting required and
press "ENTER" to select the options.
Current Configuration
Node Address : 00 C0 6C 51 14 26
I/O Address : 300H
Interrupt Request : IRQ 3
Remote Boot ROM : DISABLE
Mode : MODE 0
16-bit Etherboard Setup/Diagnostic Utility V2.12
Press S to run SETUP
Press D to run DIAGNOSTIC
Press Esc to exit
ESC Setup Diagnostic