Advantech PCI-1240, User Manual

Page: 22 / 72

PCI-1240/PCI-1240U User Manual 14
Chapter 3 Signal Connections
3.1 I/O Connector Pin Assignments
The I/O connector on the PCI-1240/PCI-1240U is a 100-pin connector
that enables you to connect to accessories with the PCL-10251 shielded
cable.
Figure 3.1 shows the pin assignments for the 100-pin I/O connector on
the PCI-1240/PCI-1240U, and Table 3-1 shows its I/O connector signal
description.
3.2 Location of Jumpers and DIP switch
Figure 3.2 shows the names and locations of jumpers and DIP switch on
the PCI-1240/PCI-1240U. There are nine jumpers, JP1 to JP9 on the PCI-
1240/PCI-1240U. Please refer to Section 3.4 Output Pulse Definition and
Section 3.11 Emergency Stop Input for more information about JP1~8
and JP9 configurations.
BoardID Switch
PCI-1240 and PCI-1240U have a built-in DIP switch (SW1), which is
used to define each card’s unique identifier for the PCI-1240/PCI-1240U
Motion Utility. You can determine the BoardID identifier on the register
as shown in Table 3-2. When there are multiple cards on the same chas-
sis, this BoardID setting is useful for identifying each card’s unique
device number.
We set the BoardID switch of PCI-1240/PCI-1240U to 0 at the factory. If
you need to adjust it to another number, set SW1 by referring to Table
3.3.
Note The PCL-10251 shielded cable is especially
designed for the PCI-1240/PCI-1240U to reduce
noise in the analog signal lines. Please refer to
Section 1.4 Accessories.