Advantech IPC-622 Series, User Manual

Page: 5 / 42

v IPC-622 User Manual
Safety Instructions
1. Read these safety instructions carefully.
2. Retain this user manual for future reference.
3. Disconnect this equipment from all AC outlets before cleaning. Use a damp
cloth the clean the equipment. Do not use liquid or spray detergents.
4. For pluggable equipment, the power outlet socket must be located near the
equipment and easily accessible.
5. Protect this equipment from humidity.
6. Place this equipment on a reliable surface during installation. Dropping or letting
the equipment fall may cause damage.
7. The openings on the enclosure are for air convection. To prevent the equipment
from overheating, do not cover the openings.
8. Ensure the power source voltage is correct before connecting the equipment to
the power outlet.
9. Position the power cord away from high-traffic areas. Do not place anything over
the power cord.
10. All cautions and warnings on the equipment should be noted.
11. If idle for a long time, disconnect the equipment from the power source to avoid
damage by transient overvoltage.
12. Do not pour liquid into the openings. This may cause fire or electrical shock.
13. Never open the equipment. For safety reasons, the equipment should only be
opened by qualified service personnel.
14. If one of the following occurs, have the equipment checked by service person-
nel:
 The power cord or plug is damaged.
 Liquid has penetrated into the equipment.
 The equipment is exposed to moisture.
 The equipment is malfunctioning or does not operate according to the user
manual.
 The equipment has been dropped and damaged.
 The equipment shows obvious signs of breakage.
15. Do not store this equipment in an environment where the temperature fluctuates
below -20 °C (-4° F) or above 60 °C (140 °F) as this may cause damage. This
equipment should be stored in a controlled environment.
16. The battery is at risk of exploding if incorrectly replaced or installed. Replace
only with the same or equivalent type recommended by the manufacturer. Dis-
card used batteries according to the manufacturer’s instructions.
The sound pressure level at the operator position does not exceed 70 dB (A), as per
the IEC 704-1:1982.
DISCLAIMER: These instructions are provided in accordance with the IEC 704-1.
Advantech disclaims all responsibility for the accuracy of any statements contained
herein.