ICR-1601
74
Short GI
By default 400ns is
selected
Short GI (Guard Interval) is defined to set the sending interval between
each packet. Note that lower Short GI could increase not only the transition
rate but also error rate.
TX Rate
By default Best is
selected
It means the data transition rate. When Best is selected, the device will
choose a proper data rate according to signal strength.
RF Bandwidth
By default Auto is
selected
The setting of RF bandwidth limits the maximum data rate.
Transmit Power
By default 100% is
selected
Normally the wireless transmitter operates at 100% power. By setting the
transmit power to control the Wi-Fi coverage.
WIDS
The box is
unchecked by
default
The WIDS (Wireless Intrusion Detection System) will analyze all packets and
make a statistic table in WiFi status.
Go to Status > Basic Network > WiFi tab for detailed WIDS status.
Save
N/A
Click the Save button to save the current configuration.
Undo
N/A
Click the Undo button to restore configuration to previous setting before
saving.
2.3.4
Uplink Profile
This device provides WiFi Uplink function for connecting to a wireless access point just like connected
to a wired WAN or cellular WAN connection. It can operate as a NAT gateway and link the devices wirelessly
to the uplink network or hosts.
To connect to the wireless access point, user has to enable the wireless Uplink function for a certain
WiFi Module (refer to Basic Network > WAN & Uplink > Physical Interface, Internet Setup tabs) first, and
then configure the Uplink profile(s) for the access point to be connected to in the Uplink Profile page.
Go to Basic Network > WiFi > Uplink Profile tab for configuring the Uplink Profile page.
Uplink Profile Setting
Setting
Item
Value setting
Description
Profile
1. A Must filled
setting.
2. Unchecked by
default.
Check the Enable box to activate the profile function.
It is available only when the selected WiFi module is configured at WiFi Uplink
mode.
Module Select
A Must filled setting.
Select the WiFi module to check or configure the expected uplink profile(s).
For those single WiFi module products, this option is hidden.