Advantech AMT-70, Installation And Operation Manual, Page: 93 / 160

AMT-70/AMT-73/AMT-75 Installation and Operation
rwcommunity = private
=> snmpcfg trapsink
trapsink = 0.0.0.0
=> snmpcfg trapcommunity
trapcommunity = public
5.12.3
The SNMP MIB source file
You can get the SNMP agent MIB source file using one of the two methods below;
1.- Through your sales representative.
2.- By uploading the file from your modem; upload the file “
amt70_mibs.mib
”
from the “
/sbin
” directory.
5.13
Modem events and logging
The modem can report unsolicited events (hardware or software) to the end-user through three
different mechanisms;
1.- The Serial Port master console interface
2.- The internal LOG file
3.- SNMP Traps
The following events are reported as follow;
Event
Trap #
Message Description LOG SNMP CONSOLE
1 Startup Completed This event occurs after the modem is
rebooted and the software is
initialized yes yes no
2 BUC Power state The BUC power was turned ON yes yes no
3 no The BUC power was turned OFF yes yes
4 LNB Power state The LNB power was turned OFF yes yes no
5 The LNB power was turned ON yes yes no
6 Modulator output state The modulator output is DISABLED yes yes no
7 The modulator output is ENABLED yes yes no
8 Modulator TX state The modulator is READY to transmit yes yes no
The modulator is in FAULT state yes yes no
9 Demodulator lock state The demod is UNLOCK yes yes no
10 The demod is LOCK yes yes no
11 Shutting down This message appears just after the
mod / demod software are resetted. yes yes no
93
Figure 3
: The modem log events 5