Advantech AMT-70, Installation And Operation Manual, Page: 101 / 160

AMT-70/AMT-73/AMT-75 Installation and Operation
Command Description
options
Display the internal code for the manufacturing options fitted
mods
Display the number of modulators installed inside the chassis.
(Always 1 for the AMT70 series)
demods
Display the number of demodulators installed inside the chassis.
The value can be 0 or 1 if a demod is fitted.
mdate
Displays the modem manufacturing date.
date
Displays the real time clock current date and time ;
To set the date and time, the format of the date is as follow;
date yyyy.mm.dd-hh:mm:ss
Configuration
Commands
rconf
Display the demodulator configuration values.
tconf
Display the modulator configuration values.
iconf
Display the interface configuration values.
Software / Firmware
Version
lver
Displays the operating system version
sver
Displays the network management software version
101
tversion
Display the modulator software version.
rversion
Display the demodulator software version (if tfitted)
Ethernet Port
Commands
netconf
Display the Ethernet ports configuration values.
tsetcfg
Set the primary address of the Ethernet port address;
The parameters are;
tsetcfg ipaddress [www.xxx.yyy.zzz] or
tsetcfg netmask [www.xxx.yyy.zzz] or
tsetcfg gateway [www.xxx.yyy.zzz]
rsetcfg
Set the secondary Ethernet port address;
The parameters are;
tsetcfg ipaddress [www.xxx.yyy.zzz] or
tsetcfg netmask [www.xxx.yyy.zzz] or
tsetcfg gateway [www.xxx.yyy.zzz]
Log Commands
listlog
List the log file
savelog
Save the log file for software download
clearlog
Purge the log file
Other Commands
uptime
Shows the elapsed time since the last reset of the operating system
on the NMC card.
twelve
Displays the power supply voltage measured on the +12 Volt supply.
This reading is accurate to approximately ±10%.
ledtests
Perform LED tests on the front panel
bye
Exit from the modem shell (Telnet mode)
reboot
Reboot [ m | all ]