21
2.4.2 2-Way Relay Card (Plug-In)
The Mxp-507 Relay
card is fitted to the
base card using 2x
plastic pillars. Refer
to the diagram
opposite.
All signals and
power required for
operation of the
card are provided
on the plug-in
connections.
Ensure that the
connections are
correctly aligned.
WARNING:
HIGH VOLTAGE INSIDE
DO NOT REMOVE COVER
No Serviceable Parts Inside
Plastic Spacers
2-Way Relay
Mounting Position for the 2-Way Relay Card
Isolate ALL sources of power before installing or removing printed circuit boards.
Observe anti-static precautions at all times when handling printed circuit boards.
2.4.3 Network Card
An Mxp-503 (STD) or an Mxp-509 (FT) Network Card can be installed onto the base card.
The card is fitted to
the base card using
1x M3 screw and 3x
plastic pillars. A
metal pillar is pre-
fitted to the base
card. Refer to the
diagram opposite.
All signals and
power required for
operation of the
card are provided
on the plug-in
connections.
Plug the ribbon
cable into the
connector as
shown.
The screw fixing is
essential for EMC
Immunity
protection.
WARNING:
HIGH VOLTAGE INSIDE
DO NOT REMOVE COVER
No Serviceable Parts Inside
Plastic Spacers
Network Interface
M3 Screws
Ribbon Cable
Mounting Position for the Network Card
Isolate ALL sources of power before installing or removing printed circuit boards.
Observe anti-static precautions at all times when handling printed circuit boards.
