Advance acoustic ADVANCE RS 501, Service Manual

Page: 36 / 155

SERVICE MANUAL ENGLISH
RS 501 33019746(2)2010-03 33
IMPIANTO DI RACCOLTA DETRITI E POLVERE
SUCTION INLET SLIDING PANELS DISASSEMBLY/ASSEMBLY
NOTE
To remove the suction inlet sliding panels, the machine must be lifted with an appropriate hoisting system. Otherwise,
remove the suction inlet assembly (D) as shown in the relevant paragraph. See the following disassembling procedures.
Place the machine on the appropriate hoisting system (if present) and lift it. 1.
If the hoisting system is not available, remove the suction inlet assembly (D) (see the procedure in the relevant paragraph).
Remove the mounting screws (A), and (B), then remove the sliding panels (C), (D), and (E).
2.
Install the new sliding panels (C), (D), and (E) and fasten them with the screws (A), and (B). 3.
Also check that, when the wheels (F) contact the ground, the sliding panels (C), (D), and (E) do not touch the ground, 4.
otherwise the wheels (F) must be replaced to avoid an excessive wear of the sliding panels (for wheel replacement procedure,
see the relevant paragraph).
Perform step 1 again.
5.
If necessary, perform the suction inlet and skirt height and operation check (see the procedure in the relevant paragraph). 6.
F E D B F
A
C
C
A
F
S301486