I
MPORTANT RECEIVING INSTRUCTIONS: Visually inspect all components for shipping damage. If any shipping damage
is found, notify carrier at once. Shipping damage is NOT covered by warranty. The carrier is responsible for all repair or
replacement costs resulting from damage in shipment.
To prevent injury keep hands away from the punch and die while punching holes. Always wear
approved eye protection.
Avoid dropping the cylinder. During punch operation, support the cylinder to prevent it from
falling after punching is completed.
To prevent thread damage, be sure punch is threaded onto the stud until the stud extends
beyond the punch. Make sure all rods, studs and punches are secured before operating
hydraulic driver.
Do not operate near live circuits. Contact with live circuits can cause injury or death.
Never exceed rated capacity of the tool. Use this tool for its intended use only.
Never operate the pump lever after the ram motion stops. Continued operation after ram motion
stops will damage driver and could result in injury.
Gardner
Bender
Instruction
Sheet
Slug-Out 90
TM
I
MPORTANT — USER SAFETY AND PROTECTION: In setting up systems to fit your operations, care must be taken to
select the proper components and design to insure appropriate integration with your operations and existing equipment and
that all safety measures have been taken to avoid the risk of personal injury and property damage from your application
or system.
GB ELECTRICAL CANNOT BE RESPONSIBLE FOR DAMAGE OR INJURY CAUSED BY UNSAFE USE, MAINTENANCE
OR APPLICATION OF ITS PRODUCTS. Please contact GB Electrical for guidance when you are in doubt as to the proper
safety precautions to be taken in designing and setting up your particular application.
!
WARNING
To Protect Your Warranty, Use Only Enerpac Hydraulic Oil.
Slug-Out 90
TM
1
⁄
2
” - 2” Self-contained Right-angle Hydraulic Knockout Set
Features
• Four-point punches for easy slug removal.
• Right-angle head swivels 360
o
for flexible punching
in tight work spaces.
• Punches up to 2
1
⁄
2
” conduit sizes in up to 12-gauge
stainless or 10-gauge mild steel.
• Compact, lightweight size: 7
1
⁄
2
pounds and 13” long.
• Operating pressure rated at 10,000 psi.
Model Description
KLP6 Hydraulic
Driver
KPR7520 Pull
Rod
KPS50 Pull
Stud
KSA50
Pull Stud Adapter
Z88010 Storage
Case
KP500B
1
⁄
2
” Punch
KD500B
1
⁄
2
” Die
KP750B
3
⁄
4
” Punch
Model Description
KPD750B
3
⁄
4
” Die
KP1000B 1” Punch
KD1000B 1” Die
KP1250B 1
1
⁄
4
” Punch
KD1250B 1
1
⁄
4
” Die
KP1500B 1
1
⁄
2
” Punch
KD1500B 1
1
⁄
2
” Die
KP2000B 2” Punch
KD2000B 2” Die
Note: Inspect tool and components for wear & damage. Replace worn, damaged, or missing components with genuine
GB replacement parts. To ensure ease of assembly & operation, keep all threads clean & lightly oiled.
KOS5290 Kit Components:
RPS-0129 3/29/00 11:11 AM Page 1
