Advance acoustic ADVANCE RS 501, Service Manual

Page: 39 / 155

ENGLISH SERVICE MANUAL
36 33019746(2)2010-03 RS 501
IMPIANTO DI RACCOLTA DETRITI E POLVERE
HOPPER POSITION ADJUSTMENT
Empty the hopper (3); if it contains a small quantity of waste, it is not necessary to dump it. 1.
Drive the machine on a solid and level ground, then engage the parking brake with the lever (66). 2.
Open the right and left doors (20) and (18) by releasing the fasteners (21) and (19) with the supplied key. 3.
Lift the hopper (3), according to the procedure shown in the Instructions for use Manual. 4.
Turn the ignition key (76) to OFF position and remove it. 5.
Remove the locking pins (28) from the housings (29) and place them into the holes (30). 6.
Loosen the locknut (A). Perform the same procedure on the left side. 7.
Insert a lever into the hole (C), then turn the top link lever (B) as necessary. Perform the same procedure on the left side. 8.
Remove the locking pins (28) and place them into the holes (29). 9.
Lower the hopper (3), according to the procedure shown in the Instructions for use Manual, and check that the profi le (D) 10.
match the frame profi le (E) on both right and left side.
If necessary, perform steps 4, 5, 6, 8, 9 and 10 again.
11.
Then perform steps 3, 4, 5 and tighten the locknuts (A). 12.
Lower the hopper (3), according to the procedure shown in the Instructions for use Manual, and check that the hopper suction 13.
hole (F) match the suction hose gasket (G). If necessary, adjust the position of the suction hose (H) according to the procedure
shown in the following steps.
Perform steps 4, 5 and 6 again.
14.
Loosen the left and right side screws (I) (J) and (L), then adjust the position of the suction hose (H). Tighten the left and right 15.
side screws (I) (J) and (L).
Lower the hopper (3), according to the procedure shown in the Instructions for use Manual, and check that the hopper suction
16.
hole (F) match the suction hose gasket (G).
Close the right and left doors (20) and (18) by engaging the fasteners (21) and (19) with the supplied key.
17.