ADTRAN 1202011L1, User Manual

Page: 69 / 162

Chapter 6. Configuring DTE Options
61202011L1-1 DSU III AR User Manual 6-15
SR Options
The SR O
PTIONS
menu is used to select the operating mode for the
data set ready (SR) lead. From the DTE options menu, press
Shift +
A
to activate the SR O
PTIONS
submenu; then press E
NTER
to select.
The factory default setting is O
FF
T
EST
O
NLY
(see Figure 6-11).
Table 6-10 shows the AT commands for setting SR O
PTIONS
.
1= NETWORK OPT.
1= LOCAL 1= DTE RATE
2= DTE OPTIONS 2= CONNECTOR TYPE
3= DATA FORMAT
3=CONFIG 4= DTE CMD OPTION
5= TRANSMIT CLOCK
2= REMOTE ENTER ADDRESS 3= TEST OPTIONS 6= CS OPTIONS
4= DIAL OPTIONS 7= ANTI-STREAM 1= FORCED ON
5= MANUAL COM. 8= CD OPTIONS 2= OFF OOS ONLY
9= TR OPTIONS 3= OFF LOCD ONLY
A= SR OPTIONS 4= OFF TEST ONLY
B= AUXILIARY PORT 5= OFF TEST +OOS
6= OFF TEST + LOCD
Figure 6-11. Setting SR Options
Table 6-10. SR Options AT Commands
Front Panel AT Command Description
1=FORCED ON &S0 Always on
2=OFF OOS ONLY &S1 Off when network Out Of Service
(OOS)
3=OFF LOCD ONLY &S3 Off 5 seconds after disconnect (SW56
only)
4=OFF TEST ONLY &S0_C0 Off when unit is in test
5=OFF TEST +OOS &S1_C0 Off in test or OOS
6=OFF TEST +LOCD &S5 Off 5 seconds after disconnect or test