ADTRAN 1202011L1, User Manual

Page: 61 / 162

Chapter 6. Configuring DTE Options
61202011L1-1 DSU III AR User Manual 6-7
DTE Command Option
The DTE C
OMMAND
option is used to enable AT commands from
the DTE, enable V.25 bis SDLC (Synchronous Data Link Control)
commands, enable V.25 (Bisync and Async), or disable all DTE
command modes (see Figure 6-5).
1= NETWORK OPT.
1= LOCAL 1= DTE RATE
2= CONNECTOR TYPE
3= DATA FORMAT
3=CONFIG 2= DTE OPTIONS 4= DTE CMD OPTION 1= DISABLED
5= TRANSMIT CLOCK 2= AT COMMAND SET
2 =REMOTE ENTER 3= TEST OPTIONS 6= CS OPTIONS 3= V.25 SYNC
ADDRESS 4= DIAL OPTIONS 7= ANTI-STREAM 4= V.25 BSC/ASYNC
5= MANUAL COM. 8= CD OPTIONS
9= TR OPTIONS
A= SR OPTIONS
B= AUXILIARY PORT
Figure 6-5. Selecting DTE Command Option
When the unit is in DTE CMD O
PTION
mode (idle in SW56 mode, forced
with TR option, or from escape sequence in AT mode) with AT C
OMMAND
S
ET
or V.25 S
YNC
selected, the DTE format is independent of the D
ATA
F
ORMAT
option. However, if V.25 BSC/A
SYNC
is selected, the unit will
use V.25 B
ISYNC
(BSC) commands for synchronous data format or V.25
A
SYNC
commands for asynchronous data format.