ADTRAN 1202011L1, User Manual

Page: 38 / 162

Chapter 4. Configuration Overview
4-2 DSU III AR User Manual 61202011L1-1
additional configuration is required to put the unit into service. If
profile 1 does not match system requirements, it can be modified,
or one of the other profiles that more closely matches the system
requirements can be loaded into current memory. When a different
profile is loaded, or the existing profile is modified, it is stored in
the current (nonvolatile configuration) memory. The DSU III AR is
then configured with that profile every time power is turned on or
until the unit is reset.
For detailed information on configuration see Chapter 5, Network
Configuration on page 5-1, Chapter 6, Configuring DTE Options on
page 6-1, Chapter 7, Configuring Test Options on page 7-1, Chapter 8,
Configuring Dial Options on page 8-1, and Chapter 9, Manual
Command on page 9-1.
Configuration Methods
The DSU III AR responds to the following methods of
configuration:
• VT-100 Compatible Terminal
• AT Commands
• V.25 Commands
• Front Panel Commands
• Remote Commands from another DSU running SLIP/PPP
protocol.
The DSU III AR provides methods for both local and remote
configuration. These methods are shown in Table 4-1.
Table 4-1. Configuration Methods
Stand Alone
Method Local Remote
AT Commands Yes Yes
V.25 Commands Yes Yes
Front Panel Yes Yes
DATAMATE No Yes
VT-100 Yes Yes