ADTRAN 1200270L1, Manual

Page: 53 / 132

61200270L1-20 DSU III ARdc User Manual 6-1
Chapter 6
Configuring DTE Options
DTE OPTIONS
The DTE OPTIONS menu is used to select the configuration parameters
that control the operation of the DSU III ARdc's DTE interface.
DTE Rate
The selectable DTE rates over a 56 or 64 kbps loop are shown in Figure 6-
1 . If a slower loop rate is selected, then the DTE rate will either match the
loop rate or it can be set to 1.2K (see Figure 6-2 on page 6-3). The factory
default setting is
S
AME
A
S
L
OOP
.
Figure 6-1. DTE Rates for 56 or 64 kbps Loop Rate
The equivalent AT commands for setting the DTE rate for a 56 kbps loop
rate are shown in Table 6-1 on page 6-2.
1=2.4K
1=NETWORK OPT. 2=4.8K
3=9.6K
1=DTE RATE 4=19.2K
5=38.4K
6=56K/57.6K FOR 64kpbs Loop
7=SAME AS LOOP 1=SCRAMBER OFF
2=CONNECTOR TYPE 8=1.2K 2=SCRAMBLER ON
1=LOCAL 3=DATA FORMAT 3=SUPPRESS LBE
2=DTE OPTIONS 4=DTE CMD OPTION
3=CONFIG 5=TRANSMIT CLOCK
2=REMOTE ENTER ADDRESS 6=CS OPTION
7=ANTI-STREAM
8=CD OPTIONS
9=TR OPTIONS
3=TEST OPTIONS A=SR OPTIONS
4=DIAL OPTIONS
5=MANUAL COMMAND