ADTRAN 1200270L1, Manual

Page: 58 / 132

Chapter 6. Configuring DTE Options
6-6 DSU III ARdc User Manual 61200270L1-20
DTE Command Option
The D
TE
C
OMMAND
option is used to enable AT commands from the DTE,
enable V.25 bis SDLC (synchronous data link control) commands, enable
V.25 (bisync and async), or disable all DTE command modes (see Figure 6-
5 ).
Figure 6-5. Selecting DTE Command Option
When the unit is in D
TE
C
MD
O
PTION
mode (idle in SW56
mode, forced with TR option, or from escape sequence in AT
mode) with
AT C
OMMAND
S
ET
or V.25 S
YNC
selected, the DTE
format is independent of the D
ATA
F
ORMAT
option. However, if
V.25 B
SC
/A
SYNC
is selected, the unit will use V.25 BISYNC
(BSC) commands for synchronous data format or V.25 ASYNC
commands for asynchronous data format.
1=NETWORK OPT.
1=DTE RATE
2=CONNECTOR TYPE
3=DATA FORMAT
1=DISABLED
4=DTE CMD OPTION 2=AT COMMAND SET
2=DTE OPTIONS 3=V.25 SYNC
4=V.25 BSC/ASYNC
1=LOCAL
5=TRANSMIT CLOCK
3=CONFIG 6=CS OPTIONS
2=REMOTE ENTER ADDRESS 7=ANTI-STREAM
8=CD OPTIONS
9=TR OPTIONS
3=TEST OPTIONS A=SR OPTIONS
4=DIAL OPTIONS
5=MANUAL COMMAND