adt-audio ToolMod Faderbox, Installation Manual

Page: 42 / 60

adt-audio

ToolMod Faderbox
modular Summing Mixer
42
®
®
Frame Version inner Width Width Desktop Version Width Rack Version
- - incl. Screw Heads incl. Brackets
5 Channel Frame 200 mm / 7.875" 210 mm / 8.25" 254 mm/10"-
241.5 mm/9.5" *)
19" Frame 440 mm / 17.332" 448 mm / 17.635" 483 mm / 19"
20 Channel Frame 800 mm / 31.375" 810 mm / 31.9" 835 mm / 32.87"
* 254 mm for 10" Rack (Standard), 241.5 mm for 9.5-Zoll / 0.5 * 19" Racks by different Brackets
Frame Version Width build-in Version
incl. Brackets
Cut-Out Size
flush fitting
Cut-Out Size
ascending 8°
5 Channel Frame 260 mm / 10.24" 212 x 268 mm
8.35 x 10.55"
212 x 274 mm
8.35 x 10.78"
19" Frame 489 mm / 19.25" 450 x 268 mm
17.72 x 10.55"
450 x 274 mm
17.72 x 10.78"
20 Channel Frame 851 mm / 33.5" 812 x 268 mm
32 x 10.55"
812 x 274 mm
32 x 10.78"
(W * H)
Dimensions
The ToolMod Faderbox with a total height of 266 mm / 10.5” fits into 6U
when mounted in a rack. The maximum depth of the frame is 150 mm / 6”.
The image on the next page shows the side view and cross section. The ta-
ble below shows the different dimensions and the necessary size of a cut-
out if the Faderbox is installed in a console or table.
Some Remarks
The column ‘Width Desktop Version ’ refers to the overall width including screw
heads.
A none-standard version of the rack brackets is needed if a 5-channel Faderbox
is installed in a 9.5” (1/2 * 19”) rack. With the standard brackets, the 5-channel-
box fits into a 10” / 254 mm rack. Since some computer equipment uses this si-
ze, 10” racks are available at reasonable prices.
Installing the Faderbox in a Desk or a Console
To install a Faderbox in a cutout of a desk or console, just check the necessary
size of the cutout in the table. It is possible to fix the console from the top or
the bottom, flush with the table surface or at an angle of 8 degrees.
Faderbox Frames