adt-audio ToolMod Faderbox, Installation Manual

Page: 6 / 60

adt-audio

ToolMod Faderbox
modular Summing Mixer
6
®
®
ly fuses with the original values. Other fuses can cause damage, fire, and/
or electric shocks.
WARNING: RISK OF DEATH BY ELECTRIC SHOCK!
Unplug the power supply units before lightning storms or
when unused or unattended for long periods. This will pre-
vent damage to the power supply units from lightning and
power line surges.
WARNING: DO NOT TOUCH OR DISCONNECT DEVICES
DURING A LIGHTNING STORM
RISK OF DEATH BY ELECTRIC SHOCK!
Ventilation slots and/or openings prevent the devices from overheating. Do
not block or cover ventilation openings. Never place the units on a soft sur-
face (carpet, sofa, pillow, etc.). Make sure to provide enough space (4 to 5
cm / 2 inches) around the devices, when mounting into a rack or cabinet.
Do not attempt any alterations to the units without express written appro-
val from adt-audio Karl Juengling! Unauthorized alterations void any war-
ranty and liability!
Module Frames
It is not necessary to remove cover sheets
when installing or removing modules. Mo-
dules can be removed and exchanged after
unbolting the knurled screws that fix the
modules in the frame. Additional modu-
les can be installed after removing blind
panels, where necessary.
Do not remove cover sheets of the frames
and do not make any changes. The sup-
ply voltages of +/- 25 volts and 48 volts
DC are accessible inside the frames. Alt-
hough these voltages are low, there is still
the risk of electric shocks.
Important Note:
In no event, open the housing of the power supply units before the power
cord is disconnected. Wait at least 5 minutes after disconnecting the cord
to avoid exposure to residual voltage. Otherwise, no liability will be assu-
med.
Safety Instructions