adt-audio ToolMod Faderbox, Installation Manual

Page: 9 / 60


ToolMod Faderbox
modular Summing Mixer
9
adt-audio
®
®
if you have not purchased directly from the factory
• a brief description of the problem and of the history
(fluids in the device, something that happened, etc.)
We will tell you how to proceed.
Cleaning
Before you begin to clean devices, disconnect the power cord. Clean only with
a dry cloth and do not use any solvents or sprays! For removing stubborn conta-
minations, you may use a cloth soaked with isopropyl alcohol as cleaning agent.
Isopropyl alcohol does not attack the powder coating and the plastic parts.
Make sure that the alcohol is entirely evaporated before you reconnect the
unit to the power line. Otherwise, you risk fire and electrical shocks!
Power Supply
The ToolMod Faderbox uses the same power supply units, cables, and con-
nectors as the ToolMod Pro-Audio module system, the ToolMix summing
boxes, and the ToolKit channel strip. A range of linear power supply units
is available for these devices. Using the same power supply unit for sever-
al different units is possible.
Mains Voltages and Frequencies
All power supply units are suited for 230 and 115 volts ac power lines with 50
or 60 Hz.
Output Voltages
All supply units d/- 25 volts for the au-
dio amplifiers of the ToolMod Faderbox and
an additional 48 volts phantom power for con-
denser microphones.
Power Cables
6 core, high cross section control cables with
5-pin XLR connectors are used for the connec-
tion between the power supply units and the
frames and between frames. The pin assign-
ment of the 5-pin XLR connectors is compa-
Power Supply