Hardware Doctor Utility
•
81
Note:
Only the fan with three output pins can be monitored!
Temperature:
All temperature-monitoring items only permit users to change the high limit,
and the low limit will be set automatically as the high limit minus 5 degree C.
Once the CPU/System temperature over the high limit, the warning
message will pop up and status will turn "Red". The status will not recover
to be " Green" until the temperature gets lower than the high limit minus 5
degree C. Currently we have one thermostat on board for CPU temperature.
You can use another thermostat connect to JP6 (two pins connector) as
system temperature sensor.
Summary of Contents for NuPRO-598 Series
