42
•
BIOS Configuration
Typematic Rate (Chars/Sec)
When the typematic rate is enabled, the system registers repeated
keystrokes speeds. You can select speed range from 6 to 30 characters per
second. By default, this item is set to
6.
Typematic Delay (Msec)
When the typematic rate is enabled, this item allows you to set the time
interval for displaying the first and second characters. By default, this item is
set to
250msec.
Security Option
This field allows you to limit access to the System and Setup.
Setup
<Default>
The system always boots up and prompts for the
Supervisor Password only when the Setup utility is
called up
System
The system prompts for the User Password e very
time you boot up
Note:
To disable security, select PASSWORD SETTING at Main Menu
and then you will be asked to enter the password. If you do not type
anything and just press <Enter> key, it will disable security, Once
the security is disabled, you can boot up the system and access to
Setup freely.
PCI/VGA Palette Snoop
Some non-standard VGA display boards may not show colors properly.
This field allows you to set whether MPEG ISA/VESA VGA Boards can work
with PCI/VGA or not.
Enabled
PCI/VGA can work with MPEG ISA/VESA VGA
board
Disabled
<Default>
PCI/VGA can not work with MPEG ISA/VESA VGA
board
OS Select for DRAM > 64MB
This option allows the system to access greater than 64MB of DRAM
memory when used with OS/2 that depends on certain BIOS calls to access
memory. The default setting is
Non-OS/2
.
Summary of Contents for NuPRO-598 Series
