66
•
VGA Driver Installation
5
VGA Driver Installation
This chapter provides information on how to install the C&T 69000 VGA
drivers that come in the two floppy diskettes with the package. Please follow
the instructions set forth in this chapter carefully. Please note that there
must be relevant software installed in your system before you could
proceed to install the VGA drivers. It is recommended that you make a copy
of the VGA driver diskette and put the backup copy in a safe place.
5.1
Installing the Drivers for Windows 95
The following section describes the normal display driver installation
procedures for Windows 95. Use the following procedures when installing
the display drivers for Windows 95.
1.
Click
Start
. Select
Settings
, then click the
Control Panel
icon.
2.
Double click
Display
.
3.
Click
Settings
.
4.
Click
Advanced
Properties
.
5.
Click
Change
.
6.
Click
Have
Disk
....
7.
Insert the diskette/CD containing the
69000 VGA driver for
Windows 95
to the floppy disk drive/CD-ROM drive, then type in
Summary of Contents for NuPRO-598 Series
