ADLINK Technology 96864-1, User Manual

Page: 36 / 64

Installation 25
Installing the VGA driver (PXIS-2558T only)
The PXIS-2558T is equipped with a 8.4” LCD with touch panel fea-
ture. You must install the correct drivers for the LCD and the touch
panel to function.
There are two PXIS-2558T chassis derivatives: PXIS-2558T-A for
use with an ADLINK PXI-3800 Series controller and PXIS-2558T-
B for use with an ADLINK PXI-3900 Series controller. Make sure
to install the correct drivers according to the installed controllers.
You may find the VGA drivers in the ADLINK All-in-One CD. Refer
to the list below:
X
For PXIS-2558T-A with a PXI-3800 controller, the VGA
driver is located in this folder:
X:\Driver Installation\PXI Platform\PXI
controller\PXI-3800\VGA\
X For PXIS-2558T-B with a PXI-3910 or PXI-3920 controller,
the VGA driver is located in this folder:
X:\Driver Installation\PXI Platform\PXI
controller\PXI-3910_20\VGA\
X For PXIS-2558T-B with a PXI-3950 controller, the VGA
driver is located in this folder:
X:\Driver Installation\PXI Platform\PXI
controller\PXI-3950\VGA\
To install the VGA driver:
1. Connect an external monitor to the VGA port of the PXI
controller.
2. Adjust the PXI controller BIOS Setup to output the video
signals using the rear panel I/O. Refer to the PXI control-
ler documentation for details.
3. Install the correct VGA driver according to the PXI con-
troller. Refer to the list above.
4. If the VGA driver supports dual-display mode, make sure
the video signal is output to both display devices (moni-
tor and notebook). Refer to the PXI controller documen-
tation for details.