Adjust-A-Sink® E140 System by Accessible Systems Inc. | Minneapolis, MN | 612-238-4600 | www.adjustasink.com
4 of 25
STEP 2: MOUNTING THE LIFT UNIT
2A.
Carefully unpack the balance
of the Adjust-a-Sink® System and
verify all components are included
and undamaged. The Adjust-a-
Sink® System comes with most of
its components already assembled.
For installation on a wall, place
blocking behind finished wall as
shown here. If mounting to a
cabinet, have the bulkhead section
constructed of ¾” plywood and
mounted securely to framing
members.
2B.
Install the Lift Unit to the
cabinet or wall using a minimum of
four 5/16” fasteners of appropriate
type and length. Mount the top edge
of the lift unit 32.5” above the floor
for the recommended final bowl
height adjustment range.
Start by securing the unit with a
minimum of two fasteners through
the top row of mounting holes.
2C.
Remove the cable tie which
secures the slide section to the wall
mounting panel section.
Temporarily plug in the unit in and
use the buttons to raise the front
panel to its maximum height, an
extension cord may be needed.
Cable Tie