Adjust-A-Sink® E140 System by Accessible Systems Inc. | Minneapolis, MN | 612-238-4600 | www.adjustasink.com
14 of 25
TROUBLESHOOTING:
Problem: The sink raises but won’t go down.
The electric lift is capable of lifting hundreds of pounds but as a safety measure, relies on gravity
to lower the sink system. Binding or interference can stop the sink from dropping.
The system may drop very slowly without the bowl and shroud installed since there will be
less weight on the lift.
Retry when fully assembled.
The front shroud may be catching on the
trap.
Remove the shroud and retest.
Replumb the trap if it interferes.
The telescoping drain may not be plumb and is binding.
Disconnect the top section from the sink basket and verify alignment as follows.
The telescoping drain may be mounted too high. The
bottom of the drain should be about 11.5” to 12.0”
above the floor.
Adjust the drain for full movement of the sink,
reconstruct the trap.
Interference
Good at lower limit
Good at upper limit
Mis-aligned
Mis-aligned