ADIC FCR 200, Operator'S Manual

Page: 75 / 140

Configuring the FCR200 6-3
6-
Configuring the FCR200
A menu structure is used to configure the FCR200 through the
serial and telnet interfaces. The currently selected menu and
the firmware version currently executing will be displayed.
Menu items are selected by entering the number of the menu
desired, and exited by entering an ‘X’. In general, the
configuration options present in the serial interface
correspond to those available through SNMP and telnet.
The FCR200 Configuration Program allows the user to control
many configuration settings through the FCR200 serial
interface. Among these are:
• Baud rate of the serial port
• Fibre Channel address
• SCSI initiator and target IDs
• Ethernet IP and MAC addresses
• Fibre Channel-to-SCSI mapping
• SCSI-to-Fibre Channel mapping
• Trace level settings
Configuration settings may be changed and saved.
Note
Menus are not
case sensitive.
Enter uppercase
and lowercase
characters
interchangeably
when selecting
from menus.
Note
Unless otherwise
indicated, all
configuration
options set do not
take effect until
the next boot
cycle of the
FCR200 unit.