ADIC FCR 200, Operator'S Manual

Page: 59 / 140

Autobaud Feature 4-19
Autobaud Feature
The autobaud feature automatically configures the baud rate
on the FCR200. Once you set the baud rate in the terminal
emulation program, wait until the FCR200 completes the
Power On Self Test (POST) and then the Firmware
Initialization process. This can take up to 90 seconds. Then
press the Enter key five or six times and the FCR200 will
automatically detect the baud rate and configure the router.
The baud rate is then saved in the FCR200’s configuration and
will be retained through future power cycles.
The baud rate in the terminal emulation program must be set
at 9600, 19200, 38400, 57600, or 115200 for the autobaud
feature to recognize it. The FCR200 will not function properly
at any other baud rate.
Note
Hitting the Enter
key before the
POST has
completed has no
effect on the
autobaud feature.
Wait until both
the POST and the
Firmware
Initialization
processes have
completed before
hitting the
ENTER key. This
may take up to 90
seconds.