adept technology Adept Cobra i600, User Manual

Page: 63 / 150

Internal User Connectors
Adept Cobra i600/i800 Robot User’s Guide, Rev E 63
Internal User Connector Output Specifications
The output specifications in the following table apply to the EOAPWR, OP3/4, and
SOLND internal user connectors.
ESTOP Connector
This 2-pin connector provides a pair of contacts that can be used for a Breakaway E-Stop
function at the end of the arm. See
Table 5-5 . The function is disabled by default when the
system is shipped. The user must enable this function using the Configuration Manager
(see below), and connect a normally-closed circuit to pins 1 and 2. When the circuit is
opened, the system will stop in an E-Stop condition. See
Figure 5-7 .
Table 5-4. Internal User Connector Output Circuit Specifications
Parameter Value
Power supply voltage range 24 VDC (± 10%), 150 W (6 A)
(21.6 V< V
in
< 26.4 V)
Operational current range, per
channel I
out
≤
700 mA
Total Current Limitation, all channels
on.
a
a
NOTE : Total current is the sum of the output current used by output
signals 3001-3004 (SOLND and OP3/4) and any user current drawn
from EOAPWR.
I
total
≤
1.0 A @ 50 ° C ambient
I
total
≤
1.5 A @ 25 ° C ambient
On-state resistance (I
out
= 0.5 A) Ron
≤
0.32
Ω
@ 85
°
C
Output leakage current I
out
≤
25 µA
Turn-on response time 125 µsec. max., 80 µsec typical
(hardware only)
Turn-off response time 60 µsec. max., 28 µsec typical
(hardware only)
Output voltage at inductive load
turnoff (I
out
= 0.5 A, Load = 1 mH)
(+V - 65)
≤
V
demag
≤
(+V - 45)
DC short circuit current limit 0.7 A
≤
I
LIM
≤
2.5 A
Peak short circuit current I
ovpk
≤
4 A