
Thermal Hazard
Adept Cobra i600/i800 Robot User’s Guide, Rev E
31
2.10 Thermal Hazard
2.11 Working Areas
Adept robots have a Manual and an Automatic (
AUTO
) operating mode. While in
Automatic Mode, personnel are not allowed in the workcell.
In Manual Mode, operators with additional safety equipment (see
) are allowed to work in the robot workcell. For safety reasons the operator should,
whenever possible, stay outside of the robot work envelope to prevent injury. The
maximum speed and power of the robot is reduced but it could still cause injury to the
operator.
Before performing maintenance in the working envelope of the robot, High Power must
be switched off and the power supply of the robot must be disconnected. After these
precautions, a skilled person is allowed to maintain the robot. See
for the
specifications.
2.12 Qualification of Personnel
This manual assumes that all personnel have attended an Adept training course and have
a working knowledge of the system. The user must provide the necessary additional
training for all personnel who will be working with the system.
As noted in this user’s guide, certain procedures should be performed only by
skilled
or
instructed
persons. For a description of the level of qualification, Adept uses the standard
terms:
•
Skilled persons
have technical knowledge or sufficient experience to enable them
to avoid the dangers, electrical and/or mechanical.
•
Instructed persons
are adequately advised or supervised by skilled persons to
enable them to avoid the dangers, electrical and/or mechanical.
WARNING:
You can burn yourself. Do not touch the robot
base or outer link shortly after the robot has been running
at high ambient temperatures (40-50° C, 104-122° F) or at
fast cycle times (over 60 cycles per minute). The robot
skin/surface temperature can exceed 85° C (185° F).
WARNING:
Never remove any safeguarding and never
make changes in the system that will decommission a
safeguard.
Summary of Contents for Adept Cobra i600
