4286 VIP Module Installation and Setup Guide
3-2
Entering the 4286 VIP Module Programming Mode:
1.
Pick up a premises touch tone phone connected to the 4286 handset out-
put. Programming cannot be done from an off-premises phone.
2.
Enter the 2 digit phone code on the phone keypad (such as “7” followed by
“
✴
” and after hearing status announcement, press # 98. Do not press
keys while the 4286 is announcing. The 4286 will establish a phone
connection and announce the contents of programming field 00.
Programming Notes
•
New data may be entered into each field once the field contents are an-
nounced. Once accepted, the new data will be echoed back by synthesized
voice announcement. If an erroneous entry is detected, a buzzer sound
will be heard in the phone receiver, and the current field and data will be
repeated. If you wish to change the data again, it can be re-entered after
the echoed voice announcement.
•
You must wait for an echoed announcement and if satisfied with a field
entry, press “
✴
” to go on to the next field. If you want to go back one
field, press “
#
.”
•
If you do not need to program all fields, such as to modify a program al-
ready entered, press “
✴
” on the phone keypad to advance by one field un-
til desired field number is announced. For example, pressing “
✴
✴
” will
advance the field from 00 to 02.
•
Once all fields have been programmed as required and accurately echoed
back, you can hang up the phone.
•
If necessary, you will have 15 minutes to re-enter programming mode.
The 15 minute limit is to prevent the user from accidentally entering pro-
gramming mode. If more than 15 minutes have elapsed, it will be neces-
sary to remove the 12 volt power temporarily from the 4286 by
disconnecting the keyed header that connects it to the control panel (lo-
cated near the 2 relays). Wait 5 seconds before replacing the header to
restore power. Then re-enter programming mode as outlined in this sec-
tion.
System default settings are indicated by [default] following an entry.
