Section 2. Mounting and Wiring
2-3
Do NOT connect speakers in parallel.
Do NOT use a single 4-ohm speaker.
Damage to the 4286 may result.
Special Wiring Notes:
1.
Wire the 4286 VIP Module exactly as indicated in Table 2-1 and on the
Summary of Connections diagram on the inside back cover of this man-
ual, unless the control’s installation instructions indicate otherwise (due,
for example, to the use of other phone-connected devices such as an Audio
Alarm Verification unit).
2.
You MUST make a connection to the incoming Telco line via an RJ31X
jack (CA38A in Canada) and direct-connect cord, as shown in the Sum-
mary of Connections diagram, even if the system is not connected to a
central station. The 4286 will not operate properly if this is not
done.
3.
If Touch-tones are not present following access to the security system via
an on-premises phone, try reversing the pair of wires connected to termi-
nals 3 & 4 on the 4286 VIP Module, and the pair of wires connected to the
"Handset" TIP & RING terminals on the control.
4.
Connect a Caller ID unit to the security system as you would an answer-
ing machine and other phones.
Table 2-1. Wiring Connections
4286 VIP Module Terminal
Connects to:
1.
Phone In (Tip)
“Handset” TIP terminal on control
2.
Phone In (Ring)
“Handset” RING terminal on control
3.
Phone Out (Tip)
BROWN lead from direct-connect cord
4.
Phone Out (Ring)
GRAY lead from direct-connect cord
5.
Not Connected
Not Connected
6.
Audio Out
One side of speaker
7.
Audio Out
One side of speaker
