Set Up the Campus-REX System
3-22
Campus-REX RS Interface Card User Manual
4
To change the packet encapsulation format, type
then press
.
The Encapsulation option changes from HDLC to PPP.
5
To enable Spanning Tree, type
then press
. The Spanning Tree
option changes from Disable to Enable.
6
Type
then press
. The terminal prompts you to enter the local
IP address of the Campus-REX. This must be set for the Campus-REX
to respond to the application (SNMP) that uses the IP protocol.
7
Type the address, in decimal-dotted notation, then press
. The
Bridge/Router Configuration menu displays the new address.
8
Type
then press
. The terminal prompts you to enter the subnet
mask of the Campus-REX. This allows the Campus-REX to determine if
a host, such as an SNMP management station or trap receiver, is on the
same local subnet. If it is, the Campus-REX can send messages directly
to the host; if not, messages must be sent through a default router. This
must be set for the Campus-REX to respond to applications that use the
IP protocol.
9
Type the subnet mask, in decimal-dotted notation, then press
.
The Bridge/Router Configuration menu displays the new subnet mask.
10
Type
then press
. The terminal prompts you to enter the IP
address of the default router the Campus-REX uses to reach a host
(SNMP station or trap receiver) on another network.
Dec 9, 1999
ADC DSL SYSTEMS INC., CAMPUS RS, Version x.xx
13:17:00
Local Unit ID:
Campus-REX Unit #34
Local I/F:
REX
Remote Unit ID: Campus-REX Unit #12
Remote I/F: REX
Circuit ID:
Network Extension Circuit 5001
BRIDGE/ROUTER CONFIGURATION
MODE SETTING
1) Bridge/Router Mode:
Bridge
(Bridge, Router)
2) Encapsulation:
HDLC
(HDLC, PPP)
3) Timing Source:
Internal
(Internal, HDSL)
4) Spanning Tree:
Disabled
(Disabled, Enabled)
5) Local IP Address:
0.0.0.0
6) Local Subnet Mask:
255.255.255.0
7) Default Router:
0.0.0.0
8) BOOT Mode:
Local
(Local, Network)
(R)eturn
(M)ain Menu
ENTER CHOICE>
2
ENTER
4
ENTER
5
ENTER
ENTER
6
ENTER
ENTER
7
ENTER
CAD1069i5.book Page 22 Thursday, May 30, 2002 7:32 AM