ADB DTC, Instruction Manual

Page: 18 / 41

AM.04.510e - Edition 1.5 18
Install and replace the complete fixture
4.4 Remove
Parts:
- Complete fixture set. See chapter 7.
Tools:
- Lifting tool (on wheels). See § 7.5.
Install the lifting tool
1. Remove the fasteners of the mounting
support (A).
2. Dispose of the fasteners of the mounting
support.
3. Fit the wigs of the lifting tool (B) in the holes
of the cover.
4. Push down the handle (C).
5. Put the fixture (D) aside the mounting
support.
Remove
1. Disconnect the plug (A).
2. Remove the labyrinth gasket (B).
3. Dispose of the labyrinth gasket.
4. Install the new fixture. See § 4.3.
WARNING
Make sure the power is OFF when you install or remove any fixture.
CAUTION
Never hold the fixture by the cable leads. This can damage the insulation,
break the waterproof seal and cause insulation faults and water leakage.
Note
The instructions show only the lifting tool (on wheels).
Note
If you use the basic lifting tool
assembly for inset lights (see
§ 7.5, tool D), make sure you
remove the fixture vertically.
A
A
B
D
C
A
A
B
D
C
A
B