ADB Safegate RELIANCE, User Manual

Page: 23 / 76

4.0 Installation
Install the inset light fixture in a base provided by ADB SAFEGATE as follows:
Figure 2: In an 8 ‑ in base Figure 3: In a 12 ‑ in base with adapter ring
NOTICE
If the inset light fixture is to be installed on another type of base or adapter ring not provided by ADB SAFEGATE,
contact ADB SAFEGATE. The inset light fixture is fixed in the base by six M10 lock nuts or by six M10×25 or M10×22
bolts dependent on base installation.
Important
Use of incorrect combination of gaskets, bolts and nuts can create severe damages to the product installation and
create multiple safety risks.
To obtain a safe and watertight installation the O-ring and retaining bolt stated in the document must be used.
You need to know what base the light fixture will be installed in, in order to choose the correct gasket, bolts and nuts.
4.1 Unpacking the Unit
To reduce the possibility of damaging the light assembly, unpack the RELIANCE light fixtures at the installation site. If damage
to any equipment is noted, file a claim form with the carrier immediately.
When receiving the light fixture, open the box and verify that the characteristics of the light fixture correspond to the design
requirements, such as type, color etc. When installing an IQ0 light fixture where the function is to be activated at a later stage,
make sure to register product information, such as PID/SN and position of the light fixture in, for example, a site
documentation table. The information is required for remote activation and administration of IQ functionality from a
substation.
4.2 Tools required
The following tools are recommended for installation.
•
One Box spanner 16/17 mm
•
One torque wrench with a 16/17 mm socket
•
Two large flat headed screwdrivers for lifting the light fixture
•
One T20 Torx key
•
One brush or cloth
•
One 3 mm Allen key
UM-5027, Rev. 1.0, 2020/12/10 13
Copyright
©
ADB SAFEGATE, All Rights Reserved