4.2 Light Engine Assembly Calibration
Figure 3: LED Light Engine Dip Switches for Flashing
When replacing the power supply it is best to reset the LED Light Engine of the Optical Assembly. See
. To erase the
calibration on the light engine, place SW1 on DIP1 to the ON position, and apply power to the unit. When the calibration is
fully erased, the light will blink at 120 flashes per minute. Remove power from the unit. Place SW1 DIP1 back into the OFF
position.
At completion of the calibration the LED will flash off/on 8 times over a 2 second span to indicate success. Resume normal
operation.
96A0476, Rev. F, 2019/12/12
15
Copyright
©
ADB Safegate, All Rights Reserved
