ADB Safegate RELIANCE L-810 OBSL-L, User Manual

Page: 25 / 34

5.0 Troubleshooting
Problem Possible Cause Corrective Action
1. LED not lighting
Defective electronic module Replace the electronic module.
Loose wire connections Tighten wire connections.
Deteriorated wire insulation Replace wires.
Moisture present in fixture
Open and dry the fixture. Inspect the glassware for
cracks. Replace the electronic module, seals, and
damaged glassware assembly.
2. LED too dim
Dirty Glassware Clean the glass lens.
LED or electronic module failed Replace the LED or the electronic module.
3. Ice forming on lens Defective or missing arctic kit
Remove the glassware assembly and check to see
if heating element is installed. If missing or
defective install new arctic kit. See Wiring and
Figure 5 .
4. Light is flickering
At the base of the Light Engine, ensure dip switch
1 is in the OFF position
See: Figure 3
5. Light is not flashing or, is
flashing when not supposed to
At the base of the Light Engine, ensure dip switch
2 is in the correct position
See: Figure 3
96A0476, Rev. F, 2019/12/12 19
Copyright
©
ADB Safegate, All Rights Reserved